EMBEDDED ELECTRONICS INFORMATIVE SITE
AVCanModBridge - J1939 Modbus Bridge
L’AVCanModBridge is an protocol bridge from J1939 to Modbus RTU.
The conversion is done at both protocol, both physically since the 2 bus supported different physical layer, in particular J1939 leaning on Canbus (with broadcast mode) while leaning against the Modbus RTU serial line 232 or 485 (with Master / Slave).
The AVJ1939modbridge make available in Modbus data transiting in J1939, for example typical parameters are:
- Rpm motor
- Tank Level
- Engine temperature
- Instantaneous consumption
- Average consumption
The board can be used by all those working in the automation and then using products with standard protocol like as Modbus, but who need to interface to data and values of the engines.
Typical users would be:
a) Automation of coatings for vehicles and Trucks
b) generating Builders
c) boat builders;
d) Manufacturer's special vehicles